PROCOTE equipment cleaning tips
Main system (Pump, Motor, Scales and Stand)
- Purge and drain all Procote from the entire plumbing system. Use an air purge connection if supplied, or the lowest drain location.
- Disconnect the line from the discharge side of the pump and contain product.
- Run crop oil, canola oil, or mineral oil through the pump and lines to dilute the Procote. TIP: Run the system in manual mode to get the oil through the pump and drain into a bucket.
- To help prevent rust, blow or spray off the pump and other components. Address any rust issues by removing the rust, priming, and re-painting these areas.
- If possible, ensure the power is disconnected from all components to protect from power surges while not in use. Follow automation company’s recommendations.
Agitation Equipment
- Unhook air hose and remove agitation equipment.
- Clean agitation equipment .
- Store in a dust-free, dry area.
Heat Blanket
- Remove blanket from the tote.
- Refer to heat blanket manual for cleaning.
- Refer to heat blanket manual for storage conditions
You may also be interested in:
PROCOTE Applicators
See all application tips on the main page.
back
HEAT
How to maintain the proper (heat) temperature.
Go to HEAT tips
AGITATION
Agitate Procote before each use.
Go to AGITATION tips
TOTE TILT
Take a look at our tote tilting recommendations.
Go to TOTE TILTING
TOTE DRAINAGE
Tips on how to drain Procote totes.
Go to TOTE DRAINAGE
COMPATIBILITY
Check out the Procote compatibility matrix.
Go to COMPATIBILITY
ORDER OF APPLICATION
Always apply oil-based product last.
Go to ORDER OF APPLICATION
USE OLDEST PRODUCT FIRST
Tips on how to find the batch number.
Go to USE OLDEST PRODUCT FIRST
TOTE CAP REMOVAL
Tips on how to remove the tote cap.
Go to TOTE CAP REMOVAL
CHECKLIST
Pe-season / startup checklist.
Go to CHECKLIST
